Go Kart Bearings

Flanged to seat the bearing. 5/16" Thick. Mainly used for Electric Wheelchair applications. Use on a go kart would be extremely rare. For low to moderate speeds, light to medium loads.

Flanged to seat the bearing. 5/16" Thick. For low to moderate speeds, light to medium loads.

Flanged to seat the bearing. 5/16" Thick. For low to moderate speeds, light to medium loads.

(2) 1 inch ID self aligning axle bearings, with set screws. (2) sets of bearing flanges, (2) thick steel bearing hangers (weld to frame), bolts & locknuts. Everything to install a 1" Axle.

(2) 1 inch ID self aligning axle bearings, with set screws. (2) sets of 3 hole bearing flanges, (2) thick steel bearing hangers (weld to frame), bolts & locknuts. Everything to install a 1" Axle.

(2) 3/4" inch ID self aligning axle bearings, with set screws. (2) sets of bearing flanges, (2) thick steel bearing hangers (weld to frame), bolts & locknuts. Everything to install a 3/4" Axle.

0.085" Thick Steel. 2 Flanges Required for each bearing. Sold one half at a time. Order 2 flanges if you're installing 1 axle bearing. Order 4 flanges if you're installing 2 bearings.

0.085" Thick Steel. 2 Flanges Required for each bearing. Sold one half at a time. Order 2 flanges if you're installing 1 axle bearing. Order 4 flanges if you're installing 2 bearings.

Housing that Bolts the Bearing to the Rear Swingarm. 2 are used to mount each bearing: Order in Qty's of 1. Order 2 if you're installing 1 bearing, 4 if you're installing 2 bearings.